Delta Tau ADVANTAGE 900 BASIC PACKAGE Bedienungsanleitung PDF herunterladen (Seite 34)

Advantage 900 Remote Operator Pendant

CONNECTOR DESCRIPTIONS

APPENDIX A - BLUETOOTH COMMANDER –

PROGRAMMING WIRELESS UNITS

Bluetooth-enabled Remote Operator Pendants and associated relay boards are programmed at the

factory to operate as a unique pair. A particular handheld unit will communicate to a particular

relay board only if it has been programmed to do so in advance.

In some rare instances, it is necessary to field program these devices. The following instructions

describe how to do so.

Please note that a special cable is necessary to program the unit. This cable is available through

Delta Tau or can be sourced from a third-party vendor. This cable connects to J2 (USB2.0) on the

Remote Handheld unit.

Bluetooth Re-Programming Procedure

Step 1

Be sure the Advantage 900 Relay Board is connected to the PC via an unused serial port. Make

note of the port number.

Step 2

Launch the Simply Blue Commander utility which is included with all Advantage 900 systems.

The application will be located in the following folder:

C:\Documents and Settings\Advantage 900 User\My Documents\Adv900 Comm Software\Util

If you do not have this application, contact Delta Tau technical support to have it emailed to you.

Step 3

Select the Local Bluetooth Settings Folder and expand it by double-clicking (see the screenshot

on the following page).

Step 4

Double-click the Read Local Device Address and record the value as shown in the screenshot on

the following page. Confirm that the Simply Blue Commander is in “Interpret Mode” by right-

clicking in the Transport Layer Log screen and verifying that Interpret Traffic mode has been

checkmarked as shown below.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 40

Keine Kommentare

Delta Tau ADVANTAGE 900 BASIC PACKAGE Bedienungsanleitung Seite 34